public SbCylinderSectionProjector(
	float edgeTol,
	bool orientToEye
)

Public Sub New ( 
	edgeTol As Single,
	orientToEye As Boolean
)

public:
SbCylinderSectionProjector(
	float edgeTol, 
	bool orientToEye
)

new : 
        edgeTol : float32 * 
        orientToEye : bool -> SbCylinderSectionProjector

Parameters

edgeTol

Type: SystemSingle

orientToEye

Type: SystemBoolean

The position of the plane which slices the cylinder into a section is specified as a fraction of the cylinder radius with the parameter edgeTol. A tolerance value of 1.0 positions the plane down the center of the cylinder. A tolerance value of 0.5 defines the longitudinal plane halfway between the center and the outside edge of the cylinder. The default value is 0.9, so that almost half the cylinder is in front of the plane. The orientToEye parameter determines whether the plane is perpendicular to the eye, or perpendicular to the cylinder's Z axis. Setting that parameter to true (the default) specifies that the plane be perpendicular to the eye, which is most often the desired behavior.

The default view volume is undefined, and the working space is identity.

Reference