public void SetValue(
	SbBox3f box,
	SbVec3f planeNormal,
	float draggerScaleFactor
)

Public Sub SetValue ( 
	box As SbBox3f,
	planeNormal As SbVec3f,
	draggerScaleFactor As Single
)

public:
void SetValue(
	SbBox3f box, 
	SbVec3f planeNormal, 
	float draggerScaleFactor
)

member SetValue : 
        box : SbBox3f * 
        planeNormal : SbVec3f * 
        draggerScaleFactor : float32 -> unit 

Parameters

box

Type: OIV.InventorSbBox3f

planeNormal

Type: OIV.InventorSbVec3f

draggerScaleFactor

Type: SystemSingle

The clip plane will be the plane defined by planeNormal and the point at the center of box .

The dragger will be positioned at the center of box . The size of the dragger geometry will be the default size multiplied by a scale factor. This scale factor is the largest dimension of box multiplied by draggerScaleFactor . The default extent of the main part of OIV.Inventor.Draggers.SoJackDragger is 2, because it extends from -1 to 1 (note that the "arms" of this dragger extend further). Therefore to make the dragger fit inside the specified box, the draggerScaleFactor parameter should be set to 0.5.

Reference